McCulloch T22LS Workshop Manual page 14

Hide thumbs Also See for T22LS:

Table of Contents

Electrical system

Dismantle the centrifugal clutch.

502 71 27-02

Fit the piston stop no. 502 54 15-01 and

remove the nut holding the ﬂ ywheel.

NOTE!

Position the piston stop so it is clamped between the piston crown and the

combustion chamber. Not so it sticks out into the exhaust port.

521 54 83-01

Remove the ﬂ ywheel.

502 51 49-01

Remove the two screws holding the cen-

trifugal clutch.

Lift off the clutch and both support wash-

ers.

Fit piston stop no. 502 54 15-01 in the

spark plug hole.

Remove the nut holding the ﬂ ywheel.

Dismantle the ﬂ ywheel from the crankcase

using the puller no. 502 51 49-01.

Gently knock the puller screw with a

hammer, if the ﬂ ywheel sits tightly on the

crankshaft.

Assembly

Check that the cast key in the ﬂ ywheel

and key way in the crankshaft are unda-

maged.

Fit the ﬂ ywheel and centrifugal clutch. Do

not forget the washers (A).

Note the slots on the washer lie closest to

the ﬂ ywheel. Align with the equivalent pins

on the ﬂ ywheel.

Table of Contents

Chapters

Table of Contents

T22lcs