Broan ALT1 Series Installation Use And Care Manual page 14

FRAMELESS CABINET
14
Refer to the marking on brackets to determine the correct installation side and orientation.
3 X
7/64"

Align the corresponding bracket to the cabinet side, while placing rear end of bracket
against the wall. Draw a line on the outer edge of the bracket (as shown).

Slide the bracket towards the center of cabinet and align side edge to marked line,
keeping the rear end edge leaning on the wall.

Use a pencil to mark 3 holes.

Remove the bracket. Using a 7/64" drill bit, drill 3 holes where marked.

Assemble the bracket to the cabinet bottom using a Phillips screwdriver and 3 provided
countersunk wood screws. Repeat for the other cabinet side.