Bradford White UCG100H270 Installation And Operation Manual page 32

Step 3: Press "SET" button for new setting to take effect immediately. The setpoint will stop flashing. If the "SET" button is
not pressed, the new temperature setting will take effect in approximately 10 seconds.
To Change Temperature Format in Display from °F to °C or ˚C to ˚F:
Step 1: Press "SELECT" button until "°F/°C" is displayed.
Step 2: Press "SET" button to change temperature format. Symbol "°F/°C" will flash.
idle
Operational
Status
SELECT
Step 3
idle
Status Operational

SELECT
Press select
Step 1
idle
Operational
Status
SELECT
Step 2
32
setpoint
°F

SET
Press SET for setting to
take effect immediately
°F °F/°C
SET
°F °F/°C

SET
"Setpoint" flashes
for 10 seconds
"°F/°C" Flashes