Reading The Floor Temperature; Frost Protection Mode - Veria Control ET45 Installation Manual

Basic functionality
READING THE FLOOR TEMPERATURE (only in program mode 3
and 5)
With the thermostat turned on.
Press "M" once, the " FT " will be flashed, and the display will
show the floor temperature.
In program mode 2 (floor sensor) the display always shows the current
floor temperature.
In program mode 1 and 4 (room sensor) the display always shows the
current room temperature.

FROST PROTECTION MODE

To enable frost protection mode.
With thermostat turned off.
Press "M" for 3 seconds.
Select 01 (00 = disabled)
When enabled and thermostat has been turned off, the heating will be
activated if the room/floor temperature is lower than 5°C; the heating
will be stopped if the room/floor temperature is higher than 7°C.
When frost protection mode has been enabled the display will show
" ".
EN
9