Installation Of Indoor Unit - Lennox LI036CO-180P432 Owner's Manual

Installation of indoor unit

Step one: choosing installation location
Step two: install wall-mounting frame
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the
plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and
Step three: open piping hole
1. Choose the position of piping hole according to the direction of outlet pipe. The
position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
Wall
2. Open a piping hole with the diameter of Φ70 on the selected outlet pipe position.
In order to drain smoothly, slant the piping hole on the wall slightly downward to
the outdoor side with the gradient of 5-10°.
Mark in the middle of it
Space
to the
wall
above
150mm
Left
Φ70
Rear piping hole
Level meter
Rear piping hole
24
rm it with the client.
.
Wall
Space
to the
wall
above
150mm
Right
Φ70