Table of Contents
Advertisement
OSD warning messages
Before the DDC/CI function is disabled, the following message is displayed.
When the monitor enters Standby Mode, the following message appears.
If VGA or HDMI cable is not connected, a foating dialog box as shown below
appears. The monitor will enter Standby Mode after 4 minutes if left at this state.
Dell P2418HZ
or
Dell 27 Monitor
The function of adjusting display setting using PC application will be
disabled.
Do you wish to disable DDC/CI function?
Yes
Dell P2418HZ
Dell 27 Monitor
Entering Standby Mode
Dell P2418HZ
Dell 27 Monitor
Entering Standby Mode
Dell 27 Monitor
?
No HDMI Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/SE2722HR
No
SE2722HR
SE2722HR
SE2722HR
SE2722HR
Operating your monitor
│
51
Advertisement
Table of Contents
