Table of Contents
Advertisement
ID555_IFU_US_EN.book Page 15 Thursday, November 27, 2008 11:00 AM
4
Getting started
4.1
Connect the base station
1
Place the base station in a central
location near the telephone line
socket and electricity socket.
2
Connect the line cord and the
power cable to their
corresponding connectors at
the bottom of the base station
as shown.
3
Connect the other end of the
line cord to the telephone line
socket and the other end of the
power cable to the electricity
socket.
Getting started
Note
The line adaptor may not be attached
to the line cord. In this case, you have
to connect the line adaptor to the line
cord first before plugging the line
cord to the line socket.
!
Warning
Avoid placing the base station too
close to large metal objects such as
filing cabinets, radiators or electrical
appliances. This can impair the range
and sound quality. Buildings with thick
internal and external walls may impair
transmission of signals to and from
the base.
!
Warning
The base station does not have an
ON/OFF switch. Power is applied
when the power adaptor is plugged
into the unit and connected to the
electricity socket. The only way to
power down the unit is to unplug the
power adaptor from the electricity
socket. Therefore, ensure that the
electricity socket is easily accessible.
The power adaptor and telephone
line cord have to be connected
correctly, as incorrect connection
could damage the unit.
Always use the telephone line cord
supplied with the unit. Otherwise,
you may not get a dial tone.
4.2
Install your phone
Before using the handset, the
batteries have to be installed and fully
charged.
15
Advertisement
Table of Contents
