Getting Started; Connect The Base Station; Connect Your Charger; Install Your Handset - Philips XL665 Manual

XL665_IFU_US_EN.book Page 14 Friday, April 3, 2009 11:51 AM
4

Getting started

4.1

Connect the base station

1
Connect the power adapter jack to
the socket on the bottom of the
base station.
2
Connect the mains adapter to a
standard wall outlet.
3
Connect the telephone line cord to
the phone socket at the bottom of
the base station and the wall phone
socket.
14
4.2

Connect your charger

(For multi-pack models only)
1
Connect the AC power adapter to a
standard wall outlet.
4.3

Install your handset

!
Warning
CAUTION: RISK OF EXPLOSION IF
BATTERY IS REPLACED BY AN
INCORRECT TYPE. Use only with Philips,
type no.: Multi-Life 600mAh (2x 1.2V AAA
600mAh Ni-MH) rechargeable battery.
Use only the recommended type supplied
with this product. Dispose of used
batteries according to the instructions.
Note
Charge the handset(s) for 24 hours
before initial use!
1
The batteries are pre-installed in
your handset. Before charging,
remove the insulation foil by pulling
the tab off your handset.
Getting started