Change The System Pin; Reset The Default Settings; Network Settings - Philips VOIP8551B/05 Manual

16.4

Change the system PIN

The system PIN is used for registering,
deleting handsets, and protecting the
access rights to some of the other menus.
The default system PIN is 0000. You can
personalize the PIN for greater security.
1
Press .
Menu
2
Select
Settings
. Press
PIN Select
3
Enter the system PIN. Press
to make corrections.
Clear
4
Enter the new system PIN. Press
.
Enter
5
Enter the new system PIN again for
verification. Press
• The setting is saved.
Note
Write down your PIN and save it for
future use. If you have forgotten the PIN,
call your dealer for assistance.
16.5

Reset the default settings

The default settings are the original
factory settings of your phone.
1
Press .
Menu
2
Select
Settings
. Press
settings
3
Select
Reset all
settings including the network
settings,
OR
3
Select
Keep Network
settings except the network settings.
4
Press
Select
Press to confirm. Use
Enter
make corrections.
• A confirmation request is displayed.
50
> >
Advanced Change
.
OK
.
Enter
> >
Advanced
.
Select
to reset all the
to reset all the
. Enter the system PIN.
Clear
5
Press
• All settings have reset.
Note
After reset, your base's power switches
off. It will switch back on in a few seconds
after updating all the settings.
See "Default (pre-programmed) settings"
on page 59 for the original factory
settings.
. Use
16.6
This section describes the information on
viewing and changing the Internet
network settings of your phone. You shall
not need to configure the network after
setting up the phone. This section is
recommended for advanced users who
want to configure the network with their
static IP address.
!
Warning
Incorrect settings will affect Skype usage
on this phone. We recommend that you
consult your network administrator or
service provider before making any
changes to the network settings.
Reset
16.6.1 View your network setting
1
Press
2
Select
Information
3
View the information. Press
when finished.
16.6.2 DHCP
By default, DHCP is activated. If you
to
configure the network to use your own
static IP address, DHCP will be
deactivated. You can re-activate DHCP.
to confirm
Yes

Network settings

.
Menu
>
Settings Network
. Press Select.
>
OK
The System