Table of Contents
Advertisement
2 )
Press ▲▼ to enter the current code,
press the ► button to fix the number
and move the red frame pointer to the
next box.
The New Logo PIN code input dialog box
z
appears.
3 )
Repeat this step to set the new Logo
PIN code.
Attention
Be sure to note the new Logo PIN code and keep it on
z
hand. If you lost the number, you could no longer change
the Logo PIN code setting.
HDMI setup
This function is only used for HDMI input source.
1 )
Press ▲▼ to select [HDMI setup].
2 )
Press ► or the <ENTER> button.
The names for the output setting of Digital
z
R/G/B vary from equipment to equipment.
Image
J
Normal
When the output of external
equipment is set to Standard.
Enhanced When the output of external
equipment is set to Enhanced.
Sound
J
When Digital input source is input,
HDMI
Sound is set to HDMI.
When DVI input source is changed
Computer
to HDMI input source, Sound is set
2
to Computer 2.
Note
The optimum setting depends on the setting of the
z
external equipment. For details, refer to the operating
instructions of your external equipment.
Connect the computer 2 audio input signals to
z
COMPUTER AUDIO IN 1 terminal as Sound function is
set to Computer 2 and MIC function is turned on.
DIGITAL LINK signal level
To set the signal level when the DIGITAL LINK input is
selected.
1 )
Press ▲▼ to select [DIGITAL LINK
signal level] and then press the
<ENTER> button.
2 )
Press ▲▼ to switch the item.
Normal
When the output of external
equipment connected to
<DIGITAL LINK> terminal is
set to Standard.
Enhanced
When the output of external
equipment connected to
<DIGITAL LINK> terminal is
set to Enhanced.
Note
The optimum setting depends on the setting of the
z
external equipment. For details, refer to the operating
instructions of your external equipment.
Terminal
The COMPUTER 2 IN/MONITOR OUT terminal on
the back of the projector is switchable for computer 2
input or monitor output.
1 )
Press ▲▼ to select [Terminal] and
then press the <ENTER> button.
2 )
Press ▲▼ to switch the item.
Computer 2
Computer input
Monitor out
Monitor out
Note
Terminal function is not available when selecting
z
[Computer 2] to the input source. Change the input
source to the others (HDMI, Computer 1, Video, DIGITAL
LINK or S-Video) so that the Terminal function will be
available.
Power management
For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not operated for a certain period.
1 )
Press ▲▼ to select [Power
management].
2 )
Press ► or the <ENTER> button to
access the submenu.
Mode
J
1 )
Press ▲▼ and then press the
<ENTER> button to select one mode
among the items as below.
Setting
53
ENGLISH -
Advertisement
Chapters
Table of Contents
