Troubleshooting Guide (Continued); Limited Warranty - Horizon Hobby Bind-N-Fly AS3X UMX A-10 Instruction Manual

Troubleshooting Guide (Continued)

Problem
LED on receiver flashes
rapidly and aircraft will
not respond to transmit-
ter (after binding)
Control surface does
not move
Controls reversed
Motor loses power
Motor power quickly
decreases and in-
creases then motor
loses power
Servo locks or freezes
at full travel

Limited Warranty

What this Warranty Covers
Horizon Hobby, LLC, (Horizon) warrants to the original
purchaser that the product purchased (the "Product")
will be free from defects in materials and workmanship
at the date of purchase.
What is Not Covered
This warranty is not transferable and does not cover
(i) cosmetic damage, (ii) damage due to acts of God,
accident, misuse, abuse, negligence, commercial
use, or due to improper use, installation, operation or
maintenance, (iii) modification of or to any part of the
Product, (iv) attempted service by anyone other than
a Horizon Hobby authorized service center, (v) Product
not purchased from an authorized Horizon dealer, or
(vi) Product not compliant with applicable technical
regulations, or (vii) use that violates any applicable
laws, rules, or regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE,
HORIZON MAKES NO OTHER WARRANTY OR
REPRESENTATION, AND HEREBY DISCLAIMS ANY AND
Possible Cause
Less than a 5-second wait between first
powering on transmitter and connecting
flight battery to aircraft
Aircraft bound to different model memory
(ModelMatch radios only)
™
Flight battery/transmitter battery charge is
too low
Transmitter may have been bound to a
different model (or with a different DSM
Protocol)
Aircraft or transmitter is too close to large
metal object, wireless source or another
transmitter
Control surface, control horn, linkage or
servo damage
Wire damaged or connections loose
Flight battery charge is low
Control linkage does not move freely
Transmitter settings reversed
Damage to motor or power components
Battery power is down to the point of
receiver/ESC Low Voltage Cutoff (LVC)
Travel adjust value is set above 100%,
overdriving the servo
Leaving transmitter on, disconnect and
reconnect flight battery to aircraft
Select correct model memory on transmitter
and disconnect and reconnect flight battery
to aircraft
Replace/recharge batteries
Select the right transmitter or bind to the
new one
Move aircraft and transmitter to another
location and attempt linking again
Replace or repair damaged parts and adjust
controls
Do a check of wires and connections, con-
nect or replace as needed
Fully recharge flight battery
Make sure control linkage moves freely
Adjust controls on transmitter appropriately
Do a check of motor and power components
for damage (replace as needed)
Recharge flight battery or replace battery that
is no longer performing
Set Travel adjust to 100% or less and/or set
sub-trims to Zero and adjust linkages
mechanically
ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT
LIMITATION, THE IMPLIED WARRANTIES OF NON-
INFRINGEMENT, MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE. THE PURCHASER
ACKNOWLEDGES THAT
DETERMINED THAT THE PRODUCT WILL SUITABLY
MEET THE REQUIREMENTS OF THE PURCHASER'S
INTENDED USE.
Purchaser's Remedy
Horizon's sole obligation and purchaser's sole and
exclusive remedy shall be that Horizon will, at its
option, either (i) service, or (ii) replace, any Product
determined by Horizon to be defective.
Horizon reserves the right to inspect any and all
Product(s) involved in a warranty claim. Service or
replacement decisions are at the sole discretion of
Horizon. Proof of purchase is required for all warranty
claims. SERVICE OR REPLACEMENT AS PROVIDED
UNDER THIS WARRANTY IS THE PURCHASER'S SOLE
AND EXCLUSIVE REMEDY.
Solution
THEY ALONE HAVE
13
EN