Mitsubishi Electric MUZ-LN VG Series Service Manual page 45

OPERATING PROCEDURE
2. Removing the Wi-Fi interface (Photos 4, 8)
(1) Remove the front panel and the panels (U) (R) (L).
(2) Remove the Wi-Fi interface on the right side of the
panel (F). Pull out its cable, and remove the cable tie,
then remove the panel (F).
(3) Remove the screw of the V.A. clamp and remove the
V.A. clamp.
(4) Remove the screw of the electrical cover, and remove
the electrical cover.
(5) Disconnect the following connector (Photo 8):
<Indoor electronic control P.C. board>
CN110 (Wi-Fi interface)
(6) Remove the cable of Wi-Fi interface from the water
cover.
How to install the Wi-Fi interface
Note: Install the Wi-Fi interface before installing the
panel (R).
(1) Install the panel (F).
(2) Fasten the cable of Wi-Fi interface to the part
the panel (F) with a cable tie.
(3) Stow the cable of Wi-Fi interface in the area
(4) Attach the Wi-Fi interface so its cable side faces
away from you.
(5) Fasten the cable of Wi-Fi interface to the water
cover.
(6) Connect the connector of Wi-Fi interface (CN110)
to the indoor electronic control P.C. board.
(7) Install the electrical cover, and install the screw in
the electrical cover.
(8) Install the V.A. clamp, and install the screw in the
V.A. clamp.
(9) Install the panel (R).
(10) Install the panels (L) (U).
OBH766C
Photo 4
(Photo 4)
of
.
45
PHOTOS/FIGURES
Wi-Fi
B A
interface
Water cover
Lead wires of
the air purifing
device
Catch of the
water cover
V.A. clamp
Screw of the
V.A. clamp
Cable of Wi-Fi
interface
Lead wires of
the indoor coil
thermistor