Mitsubishi Electric MUZ-LN VG Series Service Manual page 23

(4) Press button to complete and transmit the weekly timer setting.
NOTE:
• Press button to transmit the setting information of weekly timer to the indoor unit. Point the remote controller toward the
indoor unit for 3 seconds.
• When setting the timer for more than one day of the week or one number,
setting. Press button once after all the settings are completed. All the weekly timer settings will be saved.
• Press button to enter the weekly timer setting mode, and press and hold
timer settings. Point the remote controller toward the indoor unit.
(5) Press button to turn the weekly timer ON. (
•When the weekly timer is ON, the day of the week whose timer setting is completed, will light.
Press button again to turn the weekly timer OFF. (
NOTE:
The saved settings will not be cleared when the weekly timer is turned OFF.
2. Checking weekly timer setting
(1) Press button to enter the weekly timer setting mode.
* blinks.
(2) Press or buttons to view the setting of the particular day or number.
(3) Press button to exit the weekly timer setting.
NOTE:
When all days of the week are selected to view the settings and a different setting is included among them,
displayed.
9-9. i-see CONTROL ( ) MODE AND ABSENCE DETECTION
In the i-see control mode, the room temperature is controlled based on the sensible temperature.
(1) Press SENSOR button with a thin instrument during COOL, DRY, HEAT and AUTO mode to activate i-see control mode ( ).
The default setting is "active".
(2) Press SENSOR button several times to cancel i-see control mode.
NOTE:
How to detect human presence
• When the air conditioner starts to operate, the i-see Sensor analyzes the temperature of a room by rotating clockwise and
counterclockwise.
• Then, it detects human presence by their motion based on their heat signatures.
Detection range
The i-see Sensor does not analyze the temperature in the following range.
• The wall surface on which the air conditioner is installed
• The spot beneath the air conditioner
• Where there is an object (such as furniture) between the place and the air conditioner
It might not detect human and objects properly on the following conditions
• When the temperature of the floor and the wall is high (such as when the air conditioner starts to operate in summer)
• When occupants are in blanket or wear heavily
• When there is an object whose temperature changes rapidly in a short time
• When windows and doors are small or they are far from the air conditioner
• When the sensor cannot detect the heat source such as of small kids or pets
• When using a floor heating or an electric carpet
• When occupants do not move after the air conditioner starts to operate
Refer to the following "Absence Detection" for
OBH766C
* which was blink-
ing goes out, and the
current time will be
displayed.
lights.)
goes out.)
and
.
23
button does not have to be pressed per each
button for 5 seconds to erase all weekly
will be