Dometic FO250SA Use And Maintenance page 33

FO250SA - FO250FSA - FO252SA - FO252FSA
Manual ignition of the oven
If the electronic ignition does not work, the manual ignition is used as a
substitute.

To generate the flame, fully press down the control knob and turn it from
position 2 to 6 (Fig. 6, page 5).
 Simultaneously ignite the burner with a match or gas lighter.
 Once the flame has been generated, press the knob down for a few
seconds so that the flame remains lit.
CAUTION!
If the burner does not turn on:
● check that there is gas in the cylinder.
If the device does not work, close the gas inlet tap and contact
your dealer.
Regulating the oven flame

To adjust the flame, turn the knob to the desired position (Fig. 6, page
5).
Position
Temperature
NOTE
As soon as the oven burner flame is turned on, it remains
at the maximum flow rate in all potions of the knob and then
automatically decreases to the minimum flow rate when the set
oven temperature is reached.
EN
2
150 °C
4
200 °C
Use
6
240 °C
33