Completing Assembly; Operation And Maintenance - NuTone HDN64 Series Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR HDN64 SERIES RANGE HOOD
READ & SAVE THESE INTRUCTIONS

COMPLETING ASSEMBLY

1. Install a 75 W (maximum) light bulb in the receptacle.
2. Install filter and light lens assembly.
3. For ductless use with charcoal filter (FKM-65): Install 2 filter clips by
sliding into the receivers on the sides of the hood fan housing.
See Figure 9.

OPERATION AND MAINTENANCE

FILTERS
IMPORTANT: The aluminium filter should be removed once a week and
washed in hot detergent water. Rinse in clear, warm water and shake off
excessive moisture before replacing. The filter may also be cleaned in
your dishwasher. Always install the aluminium filter with the domed side
away from the fan.
IN A NON-DUCTED INSTALLATION
Refer to Figure 9. In non-ducted installations use FKM-65 filter and
replace every 3-6 months as needed. Always install the FKM-65 filter first
(nearest fan) with carbon side towards fan and the aluminium
filter second. Install filter clips by sliding into brackets on side of air chamber.
CLEANING
The hood should be wiped off occasionally both inside and outside using
warm water, mild dish detergent and a soft cloth. Never use scouring powders,
steel wool pads or any other abrasive cleaners, which will destroy the
hood's finish.
FIGURE 9
3
FILTER
CLIPS
FKM-65 FILTER
(FOR DUCTLESS
OPERATION ONLY)
ALUMINUM FILTER