Page 2
PLEASE START BY READING THESE IMPORTANT SAFETY RULES • SAVE THESE INSTRUCTIONS This safety alert symbol means "Caution" - failure to comply with such an instruction involves risk of personal injury or damage to property. Please read these warnings carefully. This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and operated in strict accordance with the following safety rules.
Page 3
GATE CONFIGURATION BEFORE YOU BEGIN The drive mechanism needs room to the side permitting How far must the gate leaf open? correct installation of drive arms. Please make sure that this 90 degrees or up to 115 degrees. An opening angle in excess is available.
Page 4
GATE FITTING ELECTRONIC CONTROL The control board should be the last item to be connected, i.e. The gate fitting must be installed so that it is horizontal mounting the motors, laying the necessary cable and fitting relative to the post bracket. The distance between the gate light barriers or contact strips.
Page 5
OVERVIEW OF CONNECTIONS SAFETY Description of terminal occupancy FLASHING LAMP Mains cable connection: Usage of a flashing lamp is mandatory. It serves a safety-related Terminal 1 N (blue) purpose in that it warns persons in the vicinity of the gate/door Terminal 2 PE (green/yellow) that the given gate/door is moving.
Page 6
ANTENNA DESCRIPTION OF LEDS An external antenna is not a mandatory requirement. A short LED 1 Monitors the light barrier for door closing. antenna is located on the control unit's radio adapter. Should LED ON = OK the range of the remote control need to be extended, fit an LED 2 Monitors the light barrier for door opening external antenna compatible with 433 MHz (the ANT4X-1LM...