Table of Contents
Advertisement
D
Care,
Maintenance, & Storage
D-1 Machine storage
For best results, a few simple steps can assure
your machine is well maintained after your
cleaning is complete.
1. Wrap Power Cable around Quick Release
Cable Wrap on side of machine.
2. Wipe all surfaces with a soft cloth. Store
cleaner upright in a protected, dry area.
NOTE: You may have cleaning solution
remaining in the Formula & Water Tank. You
may store your machine this way for the next
cleaning task, but never keep dirty water in
the Dirty Water Tank.
To reduce the risk of electric shock, turn power
switch off and disconnect plug from electrical
outlet before performing maintenance or
troubleshooting checks.
Do not store unit where freezing may occur.
Damage to internal components may result.
8
www.BISSELL.eu
D-2 Install the replacement
Brush Belt
1. Turn machine off and unplug from
wall outlet.
2. Remove Formula & Water and Dirty Water
Tanks.
3. Lay machine down to access bottom
of the machine.
4. With a Phillips-head screwdriver, unscrew
Belt Cover and remove.
5. Remove Brush End Cap and remove
Belt from Brush Roll.
6. Brush Roll can now be removed.
7. Belt can be removed by sliding off
motor pulley.
8. Clean or replace Belt. Attach Belt to
motor pulley and brush, insert brush into
right side end cap.
9. Reattach the left end cap and slide brush
back into place.
10. Replace Belt Cover and screw into place.
11. Manually rotate brush to make sure it
rotates freely and that belt is aligned properly.
Advertisement
Table of Contents
