Fanimation Torto FP7900MG Owner's Manual page 5

How to Assemble Your Ceiling Fan (cont'd)
3. Loosen the two setscrews in the Downrod Support.
Align the Clevis Pin holes in the Downrod with the holes
in the Downrod Support. Install the Clevis Pin and secure
with the Hairpin Clip. (Figure 2) Be sure to push the
straight leg of the hairpin clip through the hole near the
end of the clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip must be
properly installed to prevent the clevis pin from working
loose. Pull on the Downrod to make sure the clevis pin is
properly installed.
4. Route wires through Motor Coupling Cover and
through opening in Canopy Screw Cover and Canopy.
Position Canopy Screw Cover and Canopy on fan
shown with open side facing up. (Figure 3)
5. Reinstall the Hanger Ball (Figure 1) on the Downrod
as follows. Route the three 80" wires through the
Hanger Ball. Position the Pin through the two holes in the
Downrod and align the Hanger Ball so the Pin is captured
in the groove in the top of the Hanger Ball. Pull the Hanger
Ball up tight against the pin. Securely tighten the
setscrew in the Hanger Ball. A loose setscrew
could create fan wobble.
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
6. While pulling up on the hanger ball, securely tighten the
two setscrews in the downrod support. (Figure 2)
NOTE: The setscrews must be properly installed as
described above, or fan-wobble could result.
7. Slide the Motor Coupling Cover down until it touches
the top of the Housing. (Figure 3)
8. Make sure the bottom edge of the blade seats in the
external flange of the motor housing (see Blade Mount
Detail). Align the 3 holes on top of the blade and the motor
housing and securely tighten the screws (3 per blade)
provided. (Figure 4)
9. Before installing fan, measure up approximately 6-9
inches above top of Downrod/Hanger Ball Assembly. Cut
off excess wire and strip back insulation 1/2" from end of
wire.
10. You have now completed the assembly of your ceiling
fan. You can now proceed with the hanging and the
electrical wiring of your fan.
NOTE:
All set screws must be checked and re-tightened
where necessary before installation. (See Maintenance,
page 8)
Hairpin Clip
Canopy
Canopy
Screw
Cover
5
Motor
Coupling
Cover
Screw (2)
Figure 2
Figure 3
Blade
Bottom
Edge of
Blade
Seated in
Motor
Housing
Flange
Blade Mount
Detail
Figure 4