Philips HR2006/70 Manual page 10

EnglisH
10
8 Clean all removable parts immediately after use (see chapter 'Cleaning').
Mill (HR2006 only)
Using the mill
1 Put the ingredients in the mill beaker (Fig. 9).
You can process wet and dry ingredients.
Do not fill the mill beaker beyond the MAX indication.
2 Assemble the sealing ring on the blender blade unit. (Fig. 2)
3 Put the blender blade unit on the mill beaker (1) and screw the blade unit anticlockwise (2)
until it is fixed properly. (Fig. 10)
4 Turn the assembled mill upside down and screw it clockwise onto the motor unit
('click') (Fig. 11).
5 Put the mains plug in the wall socket.
6 Switch on the appliance and let it run until the ingredients are fine enough.
This takes approx. 10-30 seconds.
Disassembling the mill
1 Unplug the appliance.
2 Screw the mill anticlockwise off the motor unit.
3 Turn the mill upside down and screw the blade unit clockwise off the mill beaker.
4 Clean all removable parts immediately after use (see chapter 'Cleaning').
Cleaning
Always unplug the appliance before you clean it.
Never immerse the motor unit in water, nor rinse it under the tap. Do not clean the motor unit
in the dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
Tip: Cleaning the appliance and its parts is easiest immediately after use.
1 Make sure the appliance is unplugged.
2 Disassemble all removable parts.
Do not forget to remove the blender sealing ring.
Do not touch the blades. The blades are very sharp.
3 Clean the motor unit with a moist cloth.
4 Clean the removable parts in hot water with some washing-up liquid.
Note: All parts except the motor unit can be cleaned in the dishwasher
storage
1 To store the mains cord, wind it round the base of the motor unit.