Replacing The Dustbag - Philips FC8137/01 Manual

English
10
replacement
The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.

replacing the dustbag

- Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the floor (Fig. 26).
1 Switch off and unplug the appliance.
2 Pull the cover upwards to open it.
3 Lift the dustbag holder out of the appliance.
Make sure you hold the dustbag upright when you lift it out of the appliance.
4 Pull at the cardboard tag to remove the full dustbag from the holder (Fig. 27).
When you do this, the dustbag is sealed automatically.
,
5 Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder as
far as possible. (Fig. 28)
6 Put the dustbag holder back into the vacuum cleaner (Fig. 29).
Note: If no dustbag has been inserted, you cannot close the cover.
7 Push the cover downwards to close it.
replacing the hEpa exhaust filter
Always unplug the appliance before you replace a filter.
Replace the HEPA exhaust filter every 12 months.
- To remove the old filter and place the new filter, follow the instructions for removing and
placing the filters in section 'Cleaning the HEPA exhaust filter' in chapter 'Cleaning and
maintenance'.
ordering dustbags
- Philips Classic s-bag ® synthetic dustbags are available under type number FC8021.
- Philips Clinic s-bag ® high filtration synthetic dustbags are available under type number FC8022.
- Philips Anti-odour s-bag ® synthetic dustbags are available under type number FC8023.
- Reusable dustbags (some countries only) are available under code number 4322 004 93370.
Note: Please visit www.s-bag.com for more information about the s-bag.
ordering filters and accessories
- HEPA exhaust filters are available under type number FC8070.
storage
1 Switch off and unplug the appliance.
2 Press the cord rewind button to rewind the cord (Fig. 30).
3 Put the appliance in upright position. To attach the nozzle to the appliance, insert the ridge on
the nozzle into the storage slot.
Note: To ensure stable storage of the telescopic tube, adjust the tube to the shortest length.