Reloading The Laundry; Changing The Programme; Interrupting Or Ending The Programme - Siemens WD15H542EU Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Operating the appliance
en
w lights up: The childproof lock is
activated.
w flashes: The childproof lock is
active and the programme selector
has been adjusted. To prevent the
programme from terminating, reset
the programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. Then deactivate the
childproof lock before the programme
starts and, if required, re-activate after
the programme starts.

Reloading the laundry

When the programme has started, the
laundry can be reloaded or taken out as
required.
Select Start/Reload !. The washer
dryer checks whether a reloading is
possible.
Notes
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
A:02 + PAUS ~ Reloading is not
possible. To continue the
programme, select the Start/Reload
! button.
v + OPEN are lit ~ Reloading is
possible.
Do not open the door until both the
symbols v + OPEN are lit.
Do not leave door open for
a prolonged period – water could
run out of the laundry.
The reloading function cannot be
activated during the drying phase.
18

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select Start/Reload !.
1.
Select another programme. If
2.
required, adjust the default settings
and/or select other additional
funtions.
Select Start/Reload !. The new
3.
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
Select Start/Reload !.
1.
To cool down laundry: Select
2.
q Rinse/Spin 0.
Select Start/Reload !.
3.
For programmes at low temperature:
Select Start/Reload !.
1.
Select q Rinse/Spin 0 or
2.
Empty p.
Select Start/Reload !.
3.
For drying programmes:
Select Intensive Dry Ù or
1.
Low Heat Dry ^.
Press button Ù (Drying) and set
2.
drying time to 15 min.
Select Start/Reload !.
3.

Advertisement

Table of Contents
loading

Table of Contents