Gigabyte MZ72-HB2 User Manual page 59

Parameter
MBA Configuration Menu
(continued)
iSCSI Boot Configuration
Menu
Blink LEDs
Link Status
Physical Link Speed
Chip Type
PCI Device ID
Bus:Device:Function
Permanent MAC Address
Virtual MAC Address
Restore Defaults
Description
Setup Key Stroke
Š
– Configures key strokes to invoke the configuration menu.
– Options available: Ctrl-S, Ctrl-B. Default setting is Ctrl-S.
Banner Message Timeout
Š
– Selects the timeout value. (0 defaults to 4 seconds, 15 is no delay,
1-14 is timeout value in seconds)
– Default setting is 4.
Pre-boot Wake On LAN
Š
– Configures Pre-boot Wake on LAN (WOL).
– Options available: Enabled, Disabled. Default setting is Disabled.
VLAN Mode
Š
– Configures the virtual LAN (VLAN) mode.
– Options available: Enabled, Disabled. Default setting is Disabled.
VLAN ID
Š
– Configures the VLAN ID (1...4094).
– This item is available only when VLAN Mode is Enabled.
Boot Retry Count
Š
– Selects the number of boot retries.
– Options available: No Retry, 1 Retry, 2 Retries, 3 Retries, 4 Retries,
5 Retries, 6 Retries, Indefinite Retries. Default setting is No Retry.
Press [Enter] to configure advanced items.
Identifies the physical network port by blinking the associated LED.
Press the numeric keys to adjust desired values.
Specifies the link status of the port.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the MAC address of the Ethernet controller.
Displays the virtual MAC address of the Ethernet controller.
Resets the adapter to factory defaults.
BIOS Setup
- 59 -