Table of Contents
Advertisement
Parameter
USB hardware delays and time-outs
USB transfer time-out
Device reset time-out
Device power-up delay
Description
Selects the time-out value for USB Control/Bulk/Interrupt transfers.
Options available: 1 sec, 5 sec, 10 sec, 20 sec.
Default setting is 20 sec.
Selects the time-out value during a USB mass storage device
reset.
Options available: 10 sec, 20 sec, 30 sec, 40 sec.
Default setting is 20 sec.
Maximum time the device will take before it properly reports itself
to the Host Controller. "Auto" uses default value: for a Root port it
is 100 ms, for a Hub port the delay is taken from Hub descriptor.
Options available: Auto, Manual. Default setting is Auto.
BIOS Setup
- 49 -
Advertisement
Table of Contents
