Philips GC2810/02 Manual page 16

EnGlISh
16
Problem
Water drips
from the
soleplate after
the iron has
cooled down or
has been stored.
Water spots
appear on the
garment during
ironing.
4239.000.7163.1.indd 16
Cause
The set
temperature is too
low for steam
ironing.
You have put an
additive in the
water tank.
You have used the
steam boost
function at a
setting below
3.
You have used the
steam boost
function too often
within a short
period.
You have put the
iron in horizontal
position while
there was still
water in the water
tank.
These wet spots
may be caused by
steam that has
condensed onto
the ironing board.
Solution
Set an ironing temperature
that is suitable for steam
ironing ( 2 to MAX). Put the
iron on its heel and wait until
the temperature light goes out
before you start ironing.
Rinse the water tank and do
not put any additive in the
water tank.
Set the temperature dial to a
setting between 3 and
MAX.
Continue ironing in horizontal
position and wait a while
before you use the steam
boost function again.
Empty the water tank and set
the steam control to position
0 after use. Store the iron on
its heel.
Iron wet spots without steam
from time to time to dry them.
20-05-09 09:02