Philips GC2810/02 Manual page 14

EnGlISh
14
Guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your
country.
Problem
The iron is
plugged in, but
the soleplate is
cold.
The iron does
not produce any
steam.
4239.000.7163.1.indd 14
Cause
There is a
connection
problem.
The temperature
dial is set to MIN.
There is not
enough water in
the water tank.
The steam control
is set to position 0.
The iron is not hot
enough and/or the
drip-stop function
has been activated.
Solution
Check the mains cord, the plug
and the wall socket.
Set the temperature dial to the
required position.
Fill the water tank (see chapter
'Preparing for use', section
'Filling the water tank').
Set the steam position to
or (see chapter 'Using the
&
appliance', section 'Steam
ironing').
Set an ironing temperature
that is suitable for steam
ironing ( 2 to MAX). Put the
iron on its heel and wait until
the temperature light goes out
before you start ironing.
$
20-05-09 09:02