Table of Contents
Advertisement
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: Keep flue open when operating unit.
WARNING: If you do not follow these instruct-
ions exactly, a fire or explosion may result caus-
ing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted
by hand. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING smell all around the app-
liance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and
will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's in-
structions.
• If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair it,
call a qualified service technician or gas supplier.
Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
Pilot
Figure 12 - Thermopile and Pilot
10
Thermopile
OPERATION
1. STOP! Read the safety information on the
left side of this page.
2. Make sure equipment shutoff valve is fully
open.
3. Press in and turn control knob clockwise
to the OFF position.
4. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the safety
information, at left. If you don't smell gas, go to
the next step.
5. Press in and turn control knob counter clockwise
to the PILOT position.
Press in control knob for five (5) seconds (see
Figure 13).
Note: You may be running this log set for the first
time after hooking up to gas supply. If so, the con-
trol knob may need to be pressed in for 30 seconds
or more. This will allow air to bleed from the gas
system.
6. With control knob pressed in, use a match or
grill lighter to light pilot. Visually locate the pilot
(see Figure 12) on the edge of the burner pan
to look for flame.If needed, repete operation
until the pilot lights.
Figure 13 - Control Knob Location
7.
If the pilot will not stay lit after several tries, turn
the gas control knob to "OFF" and call your service
technician or gas supplier.
8. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob.
•
If control knob does not pop out when released,
contact a qualified service person or gas sup-
plier for repairs.
Note: If pilot goes out, repeat steps 3
through 8.
LIGHTING INSTRUCTION
-
Control Knob
ON
-
Advertisement
Table of Contents
