Table of Contents
Advertisement
● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Front panel
Air fi lter
(Nano platinum fi lter)
Air cleaning fi lter
(Electrostatic anti-allergy
enzyme fi lter, option)
Air inlet
Air outlet
Horizontal vane
Display section
Operation indicator lamp
Emergency
operation switch
Remote control receiving section
Outdoor unit
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
Heat exchanger
Page 4
2.
Insert the negative
pole of AAA alkaline
3.
batteries fi rst.
Install the front lid.
Remote controller
Operation display
section
OFF/ON
(stop/operate)
button
Operation select
button
Page 4
FAN speed
control button
Page 5
ECONO COOL
button
Page 6
POWERFUL
COOL
button
Page 5
VANE control
button
Page 5
Lid
Slide down
to open
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
Setting current time
1.
Press CLOCK.
3.
Press CLOCK again.
• Press CLOCK gently using a thin instrument.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Temperature buttons
Page 4
Off-timer button
Page 6
On-timer button
Page 6
WIDE VANE
button
Page 5
TIME set buttons
Pages 3, 6
Increase time
Decrease time
LONG button
Page 5
CLOCK button
Page 3
RESET button
Page 3
Remote controller
holder
• Install the remote control-
ler holder in a place where
the signal can be received
by the indoor unit.
2.
Press the TIME buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer).
Advertisement
Table of Contents
