Safety Certification Information; Transmitter Adjustments; Eu Meter Option - Hart Only; Table 2 - Available Eu Meter Characteristics - Honeywell STT700 STT700 User Manual

1.4.

Safety Certification Information

The hazardous area approvals information is listed on the nameplate which, as shown in Figure 3, is
located at the bottom of the module. The approvals nameplate contains information and service
marks that disclose the transmitter compliance information. Refer to Appendix A of this document for
safety certification requirements and details.
1.5.

Transmitter Adjustments

For HART and DE you can use the Honeywell MC Toolkit or other third-party hand-held (for
HART) to make any adjustments to an STT700 SmartLine Temperature Transmitter.
Any HART 7.0 compliant PC host like Honeywell FDM can be used to configure the device.
Honeywell FDM can also configure the STT700 with DE protocol
Alternately, certain adjustments can be made through the Experion or Universal Station, if the
transmitter is digitally integrated with a Honeywell Experion or TPS system.
EU Meter Option – HART only
1.6.
The STT700 SmartLine Temperature Transmitter can be supplied with the optional EU Meter, see
EU Meter
inside housing
EU Meter 
(HART only)


Page 4
Table 2 – Available EU Meter Characteristics
Compatibility for replacement of existing STT250 installations
o o
360 rotation in 90 increments
Standard units of measurement: °F, °C, °R, K, Ω, mV & %
STT700 Temperature Transmitter User's Manual
.
Table 2.
Revision 1