Attaching Label; Turning The Power Off - Epson LabelWorks LW-PX700 User Manual

6. Attaching label

1. Peel off the backing paper.
2. Attach the label and rub it firmly.
CAUTION
Depending on the environment where you use labels and
the nature of the adhered surface, the labels may be peeled
or discoloured, and the adhesive may remain on or damage
the adhered surface. Be sure to check the environment and
the nature of the adhered surface before use. K-Sun takes
no responsibility for any damage or loss due to the above
mentioned causes.

7. Turning the Power Off

1. Press .
The characters you have entered in the current session
are stored even after the printer is turned off. They are
displayed when it is turned on again.
2. Open the battery cover and then remove the
Li-ion battery.
If the AC adapter is connected, disconnect the AC
adapter from the printer.
CAUTION
• "Powering off." is displayed while turning off this printer.
Do not remove the Li-ion battery or disconnect the AC
adapter until this message disappears.
• When you don't use the printer for a long period of time,
remove the batteries (Li-ion battery or alkaline batteries),
disconnect the AC adapter, and remove the tape cartridge
from the printer.
Top
Start Here
Safety Instructions
Specifications
Troubleshooting
Part Names and
Functions
Start Here
Cleaning
Initializing the
Settings
Purpose-based Index
Key Menu Index
Frame and Table Lists
15