Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM
Unit fails to power on.
Airflow is diminished.
Unit is not producing
sufficient amount of heat.
POSSIBLE CAUSE AND SOLUTION
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker
/ ground fault circuit interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS.
Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Internal tip-over switch has been tripped and safety shut-off system has cut power to heater. Place heater
on level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Check filter and clean as necessary. See CLEANING.
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take several minutes.
13
English
Advertisement
Table of Contents
