Remote Control - Vornado EH1-0116-43 Owner's Manual

REMOTE CONTROL

Screwdriver required.
Your VMH500 heater remote includes (1) coin-style CR2032 battery. Battery comes pre-installed. Remove battery pull tab before first use. The
remote is located inside the EPS Styrofoam surrounding the front and back of the heater. Look for the REMOTE (
polybag inside the EPS Styrofoam.
1. For battery replacement, the remote
requires one coin-style 3V CR2032 battery.
Always use the correct size and grade of
battery for this product.
2. To replace battery, open battery door
on the back side of the remote control
(you will need to loosen the small screw
on door using a #1 Phillips screwdriver
- screwdriver not included). If necessary,
clean the battery contacts and also those
of the device prior to battery installation.
Remove any plastic protection from the
battery and place it in the remote with the
+ side facing up. Replace the battery door
and screw.
Note: Remove battery from the remote
control when not in use for an extended
period of time and always remove dead
battery immediately and replace with
fresh. Do not store dead battery in remote.
10 English
3. Your remote control will operate the
same as the control functions located
POWER
on the heater, except when changing
modes. When changing modes, both
displays will show either LO, HI or FA
THERMOSTAT -/+
on the display as you cycle through.
MODE
Once the selection is made, it will
hold for eight seconds before room
High Heat (1500
temperature is displayed again.
watts), Low Heat
(750 watts) or Fan
The remote requires a line-of-sight path
Only.
to allow for the signal to be received
TIMER
by the heater. Position the heater so
the receiver lens (inside the display
on front of heater) is visible from the
remote control.
CAUTION: DO NOT
INGEST BATTERIES.
È
) sticker affixed to the remote