Storage; Reset Heater; Troubleshooting - Vornado AVH10 Owner's Manual

STORAGE

During the off-season or after extended periods of non-use, you may
choose to store your heater. To ensure long life of the product, it is
recommended to store your heater by following these instructions:
Cleaning is recommended before storage.
1. Unplug power cord and wrap
around Cord Storage on
bottom of heater.
2. Cover, or place back in retail
carton if available. This prevents
heater from accumulating dust
over time.
3. Store heater in cool and
dry location.
DISPOSAL
Dispose of all packaging
materials in an environmentally
responsible manner.
12 English

RESET HEATER

RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multilevel safety shut-off system designed
to prevent overheating. Overheating may occur when the inlets or
outlet are blocked. If this happens, the safety shut-off system cuts
power to the heater and you must manually reset the heater.
1. Power heater off, then unplug power cord.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Press Power button On. Your Vornado Heater should now function
normally and return to last stored setting.
Note: If the safety shut-off system
repeatedly shuts off your heater or if it
will not reset after following the above
procedure, call Vornado Consumer
Services Department toll-free at
1-800-234-0604.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
Unit fails to power on.
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker has tripped or blown fuse. Reset circuit breaker or replace fuse. See
IMPORTANT INSTRUCTIONS.
Ground fault circuit interrupter (GFCI) has tripped. Ground fault circuit interrupters are not recommended
for use and may cause nuisance tripping. If tripping does occur, relocate the unit to a standard wall outlet.
Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Tip-over switch on bottom of unit has been tripped and safety shut off-system has cut power to heater.
Place heater on level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Unit is not producing a
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
sufficient amount of heat.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take several minutes.
Unit is powered on but
Press Power button Off and unplug unit. A cylindrical plunger is on bottom of unit. Push in 4–5 times,
there is no heat.
ensuring it is not stuck. Set unit down on flat surface. Be sure power cord lays completely flat and extends
from power cord opening on back of heater. Plug unit in and press the Power button On. Set to highest
heat setting and ensure it is not on Fan Only setting.
13
English