How To Use - Vornado EH1-0116-43 Owner's Manual

HOW TO USE

Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use integrated handle on top of heater for
lifting and carrying.
2. Position heater so airflow is not obstructed.
3. Unwrap power cord from storage tray on back
of heater. Plug power cord into standard
grounded wall outlet.
4. Press the Power button
and select Mode or
Fan Only . Room temperature will illuminate
on both displays. Set thermostat to desired
temperature using -/+. SET TEMP numbers
will flash on both displays as you adjust.
Once the selection is made it will flash for five
seconds, become constant for five seconds
and then returns to room temperature. The
displays will then dim after 20 seconds. Default
settings upon first use will be High Heat and set
temperature of 75 degrees.
5. Set timer to automatically power the unit off by
. 0 will flash on both top and front
pressing
displays. Press to select the amount of time in
one-hour intervals, up to 12 hours. User can also
use -/+ to select the amount of time.
After a selection is made or after five seconds
of inactivity, the number selection will stop
flashing and become constant. It is then
displayed for five seconds, before room
temperature is displayed again. To cancel the
timer operation, select 0 hours or hold
three seconds.
The white indicator light on front display and
TIMER on top display will illuminate to indicate
the timer is on.
COOL DOWN
When you power off your heater while in
High or Low heat mode, it automatically
enters a cool down routine in which the
heating element turns off and the fan
exhausts remaining heat. During Cool
Down, both top and front displays count
down before powering off completely.
for
9
English