Connecting Water Supply - Beko WJ837543W User Manual

6.4 Connecting water supply

• The water supply pressure required to run the product is
between 1 to 10 bars (0.1 – 1 MPa). (It is necessary to have
10 – 80 litres of water flowing from the fully open tap per
minute.)
CAUTION!
- Attach a pressure reducing valve if water pressure is
• Do not use old or used water inlet hoses on the new
product.
- It may cause stains on your laundry.
• Do not plug the product's cold water inlet to hot water
outlet.
- Your laundry may get damaged or the product will switch
Washing Machine / User's Manual
higher.
to protection mode and will not operate.
a) Connect the straight end of the mains inlet hose
provided with the product to the cold water tap and
the warped end to the water inlet on the back of the
product as shown in the figure.
b) Tighten all hose nuts by hand securely. Never use a
tool when tightening the nuts.
c) Open the taps completely after making the hose
connection to check for water leaks at the connection
points. If any leaks occur, turn off the tap and remove
the nut. Retighten the nut carefully after checking
the seal. Turn the tap on and repeat the checks.
d) Keep the taps closed when the product is not in use.
EN / 19