Advertisement
18
Install 2 of the screws to the side panel of
mounting bracket corresponding to the
open slotted holes on the canopy upper
rim, screws provided. Remove the thread
studs from the lower part of the mounting
bracket.
Lift fan to mounting bracket, aligning the
"L" shape holes on canopy with the
screws on the mounting bracket. Turn the
fan clockwise to lock in position. Install
the other 2 canopy mounting set screws
from the hardware pack and tighten all
screws securely.
21
Reverse switch
Setting the reverse switch in the down
position will result in downward airflow
and setting the switch in the up position
will result in upward airflow.
Note: Reverse switch must be set either
completely down or completely up for fan
to function. If the reverse switch is set in
the middle position, fan will not operate.
© 2018 Monte Carlo Fan Company
19
Blade bracket
Install blade bracket with blade by 3 blade
screws and washers provided. Tighten
screws securely. Repeat this process for
remaining blades.
22
Install fan pull chains to preassembled
pull chain on fan. Pull chain provided.
6
20
Blade
Remove shipping stabilizers from motor
assembly.
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
Shipping
stabilizers
9/2018
Advertisement
