Cleaning And Servicing; Troubleshooting - Bosch MMB66 Series Instruction Manual

en Cleaning and servicing

Cleaning and servicing

The appliance requires no maintenance!
Thorough cleaning guarantees a long
service life. An overview of cleaning the
individual parts can be found in Fig. F.
W Risk of electric shock!
Never immerse the motor block in water
and never hold under running water and do
not clean in the dishwasher.
Warning!
Do not use abrasive cleaning agents.
S urfaces may be damaged.
Tips:
– Preferably clean the parts immediately
after use. This will prevent residue from
drying on and attacking the plastic
(e.g. by essential oils in herbs).
– If processing e.g. carrots and red
cabbage, the plastic parts will become
discoloured by a red film which can be
removed with a few drops of cooking oil.
Cleaning the motor block
■ Remove mains plug.
■ Wipe motor block with a damp cloth. If
required, use a little detergent.
■ Then wipe dry.
Cleaning blade holder
W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Do not clean blade holder in the dish-
washer, but under running water using
a brush. Do not leave in water! Remove
seal for cleaning.
Cleaning the blender
The blender jug, pusher, smoothie insert, lid
and measuring cup are dishwasher-safe.
Tip: Pour a little water and washing-up liquid
into the attached blender. Switch to setting
Q for several seconds. Pour out the
water and rinse the blender with clean water.
Cleaning the universal cutter
The universal cutter jug is not
dishwasher-safe.
20

Troubleshooting

W Risk of injury!
Before rectifying a fault, pull out the mains
plug.
Important information
The illuminated ring on the rotary switch
flashes rapidly
– if the blender jug or universal cutter jug
has not been attached properly,
– if the blender jug or universal cutter jug
becomes detached during operation,
– if the motor stops during operation due
to an overload.
Fault:
Blender does not start or appliance
switches off during operation.
Possible cause:
The appliance was overloaded (e.g. tool
jammed by food) and the electronic fuse
has tripped.
Remedial action:
■ Set the rotary switch to 0/off.
■ Remove mains plug.
■ Eliminate the cause of the overload.
■ Switch the appliance on again.
Possible cause:
Blender jug or universal cutter jug has
become detached.
Remedial action:
■ Set the rotary switch to 0/off.
■ Correctly attach blender jug or universal
cutter jug and screw on all the way.
■ Switch the appliance on again.
Important information
– If the fault cannot be eliminated, please
contact customer service (see customer
service addresses at the end of this
booklet).