Package Contents; Before Installation; Unpacking & Cleaning The Monitor - Raloy RF117HDM User Manual

1.3

Package Contents


RF117HD – 1 Unit

1 x CX-6 6ft DVI-D console cable (standard)
(Alternative: CB-6 6ft VGA console cable - available on request)

1 x Power Cord

8 x M6 screw, cage nut & cup washer
Additional or fewer parts may be included depending on optional accessories such as integrated
KVM, SDI capability, audio inputs and/or DC power options.
1.4

Before Installation


It is very important to place the LCD Keyboard Drawer in a suitable environment.

The surface for placing and fixing the LCD Keyboard Drawer should be stable and level or mounted into a
suitable cabinet.

Make sure the location is well ventilated, out of direct sunlight, away from sources of excessive dust, dirt,
heat, water, moisture and vibration.
1.5 Unpacking & Cleaning the Monitor
The LCD keyboard drawer comes with the standard parts as listed in the package contents. Check and make
sure they are included and in good condition. If anything is missing, or damaged, contact the supplier
immediately.
How to Clean Your LCD Monitor
CAUTION:

To avoid the risk of electric shock, make sure your hands are dry before unplugging your monitor from or
plugging your monitor into an electrical outlet

When you clean your monitor, do not press down on the LCD screen. Pressing down on the screen can
scratch or damage your display. Pressure damage is not covered under warranty.

Use only cleansers made specifically for cleaning monitors and monitor screens. Cleansers not made to
clean monitors and monitor screens can scratch the LCD display or strip off the finish.

Do not spray any kind of liquid directly onto the screen or case of your monitor. Spraying liquids directly
onto the screen or case can cause damage which is not covered under warranty.

Do not use paper towels or abrasive pads to clean your monitor. Using an abrasive pad or any wood
based paper product such as paper towels can scratch your LCD screen.
Cleaning your Monitor
To safely clean your LCD, please follow these steps:
1. Disconnect power cord.
2. Gently wipe the surface using a clean, dry microfiber cloth. Use as little pressure as possible.
Cleaning Tough Marks and Smudges
To remove tough marks and smudges, please follow these steps:
1. Disconnect the power cord.
2. Spray a small amount of non-abrasive cleanser on a microfiber cloth.
3. Gently wipe the surface. Use as little pressure as possible.
4. Wait until your monitor is completely dry before plugging it in and powering it up.
Caution: Do not spray or apply any liquids directly onto the monitor. Always apply the solution to
your microfiber cloth first, not directly on the parts you are cleaning.
www.Raloy.com
6
1 (866) 395-5927