VTech CS6224-11 User Manual page 36

The answering Make sure the answering
system does system is on. When the
not record answering system is on,
ANS ON should display
messages.
on the handset and the
telephone base.
When the answering
machine memory is full,
it does not record new
messages until some old
messages are deleted.
If you subscribe to
voicemail service, change
the number of rings
so that your answering
system answers before
your voicemail service
answers. To determine how
many rings activate your
voicemail service, contact
your telephone service
provider.
Press VOL+ on the
The messages
telephone base or VOL
on the
answering on the handset to increase
system are very the listening volume.
difficult to hear.
The answering Make sure you have
system does set the date and time.
See Configure your
not announce
telephone section.
the correct day
of the week
for recorded
messages time
stamp.
The messages If a caller leaves a very long
on the message, part of it may be
answering lost when the answering
system are system disconnects the call
incomplete. after the preset recording
time.
If the memory on the
answering system
becomes full during a
message, the answering
system stops recording and
disconnects the call.
If the caller's voice is very
soft, the answering system
may stop recording and
disconnect the call.
The answering
system does
not respond
to remote
commands.
I subscribe to a
nontraditional
telephone
service that uses
my computer
to establish
connections,
and my
telephone
doesn't work.
I accidentally
set my LCD
language to
Spanish or
French, and I
don't know how
to change it
back to English.
29
Make sure you enter the
correct remote access
code.
Make sure you are
calling from a touch-tone
telephone. When dialing
a number, there should be
tones. If there are clicks,
then it is not a touch-tone
telephone and cannot
activate the answering
system.
The answering system
may not detect the
remote access code when
your announcement is
playing. Wait until the
announcement is over
before entering the code.
Make sure your computer
is powered on, and
your Internet is working
properly.
Make sure to plug your
USB telephone adapter
into a dedicated USB port
on your computer. Do not
plug into a multiple port
USB hub (USB splitter) that
is not powered.
In a few rare instances, the
USB port on your computer
may not have enough
power. In these instances,
try using a USB hub with
its own external power
supply.
If you are using a firewall, it
may prevent access to your
nontraditional telephone
service. Contact your
service provider for more
information.
While the handset is not in
use, press MENU and then
enter 364# to change
the handset LCD language
back to English.