Kohler K-T14420 Installation Manual page 5

1-1/4"
(3.2 cm)
2. Install the Showerhead
CAUTION: Risk of product damage. To avoid clogging the
showerhead spray outlets, use thread sealant tape on the shower
arm threads. Do not use thread sealant compound (pipe dope).
Remove the temporary nipple from the shower elbow.
Apply thread sealant and install a 1/2" NPT nipple to the shower
elbow to extend 1-1/4" (3.2 cm) beyond the finished wall.
Turn the main water supply on.
Run hot and cold water through the shower arm to flush out dirt
and debris.
IMPORTANT! If a gasket is NOT installed on the escutcheon of
the shower arm: Apply a bead of plumbers putty or other sealant to
the back of the shower arm. Refer to the putty or sealant
manufacturer's instructions for proper application. This will ensure a
watertight seal.
Apply thread sealant tape to the nipple and thread the shower
arm onto the nipple.
Carefully tighten with a clean strap wrench.
Remove all excess putty around the escutcheon.
Kohler Co.
1/2"
Nipple
5 1031692-2-C