Table of Contents
Advertisement
Faults, what to do?
Faults
Water is running out.
Water not flowing in.
Detergent not
washed in.
Washing-machine
door cannot be
opened.
Programme does
not start.
Detergent solution is
not drained.
Water not visible in
the drum.
Spin result not
satisfactory.
Washing wet/too
damp.
Spin cycle actuated
several times.
Residual water in the
dispenser for care
product.
Odour formation in
the washing ma-
chine.
Loud noise forma-
tion, vibrations and
"wandering" during
spin cycle.
50
Cause/Remedy
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
Ü
–
(Start/Pause) not selected?
– Tap not open?
– Filter blocked? Clean the filter. ~ Page 46
– Supply hose kinked or jammed?
– Safety function active. Stop programme?
$
– Rinse Hold
(without final spin) selected?
– Can be opened via emergency release only? ~ Page 48
Ü
–
(Start/Pause) or
– Door closed?
– Childlock active? Deactivate.
$
– Rinse Hold
(without final spin) selected?
– Clean the drain pump.
– Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
æ
– Less Ironing
– Too low speed selected? ~ Page 23
Not a fault – unbalanced load detection system adjusts imbalance.
– Not a fault – effect of the care product not impaired.
– If required, clean insert.
Run Cottons 90 °C programme without washing.
Use standard detergent.
– Appliance aligned?
Align the appliance. ~ Page 64
– Appliance feet fixed?
Secure appliance feet. ~ Page 64
– Transportation safety devices removed?
Remove transportation protection devices. ~ Page 58
0
(Finish in) time selected?
selected?
Advertisement
Table of Contents
