Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for STAMOS S-PLASMA 55H UK
Summary of Contents for STAMOS S-PLASMA 55H UK
- Page 1 USER MANUAL S-PLASMA 55H UK...
- Page 2 IMPORTANT SAFETY INFORMATION • Double insulated tools are equipped with a polarized plug (one blade is wider Keep this manual for the safety warnings and precautions, assembly, operating, than the other). This plug will fit in a polarized outlet only one way. If the plug inspection, maintenance and cleaning procedures.
-
Page 3: Specific Safety Rules
• Disconnect the Power Cord Plug from the power source before making any • Keep clothing free of grease, oil, solvents, or any flammable substances. Wear dry, adjustments, changing accessories, or storing the tool. Such preventive safety insulating gloves and protective clothing. measures reduce the risk of starting the tool accidentally. -
Page 4: Heat Protection
• Always keep hoses away from welding/cutting spot. Examine all hoses and cables Heat protection for cuts, burns, or worn areas before each use. If any damaged areas are found, The thermal protection circuit takes action when the device exceeds the duty cycle. replace the hoses or cables immediately. - Page 5 Grounding: At the back of each welder there is POWER INDICATOR: This indicator lights up after turning the machine a screw and a label to provide the necessary grounding. Before operating the unit it is necessary to ground the shell of the welding apparatus by means of a cable with not less than 6 mm diameter, in order to prevent potential problems caused by electricity leakages.
- Page 6 General diagram of S-Plasma 55H UK connection 4T/2T selection button Power supply cord POST FLOW = setting the time of the air flow after the cutting. Air compressor Pressure regulator TEST GAS = protection U.V LED = Under Voltage LED. This LED control light will turn on when the voltage drops under 330 V.
-
Page 7: Front View
S-PLASMA 55H UK Plasma cutters accessories FRONT VIEW REAR VIEW 1. Grounding clamp cable 2. Plasma torch with cable Detailed technical parameters: S-Plasma 55H UK 230V Input voltage 1-phase Frequency 50Hz Input current No load voltage 230 V Degree of protection of the housing... -
Page 8: Operation
Cable connections INITIATING OPERATION 1. Each plasma cutter is equipped with a main power cable, which is responsible for A. Unpacking providing current and voltage to the device and it must be connected to the suitable Unpack all the items out of the box and make sure that you have received all items power source according to plasma cutter input voltage. -
Page 9: Maintenance
INSTRUCTIONS FOR USE MAINTENANCE Check the pistol for wear damage, cracks or exposed wire sections. Replace or repair A. The beginning any such defects before using the device. A heavily worn pistol tip/nozzle contributes to the reduction of speed, voltage drops and crooked cuts. An indication of a worn Turn the power switch to „ON“. - Page 10 NOTES NOTES Rev. 04.04.2022 Rev. 04.04.2022...
- Page 11 Umwelt- und Entsorgungshinweise Hersteller an Verbraucher Sehr geehrte Damen und Herren, gebrauchte Elektro- und Elektronikgeräte dürfen gemäß europäischer Vorgaben [1] nicht zum unsortierten Siedlungsabfall gegeben werden, sondern müssen getrennt erfasst werden. Das Symbol der Abfalltonne auf Rädern weist auf die Notwendigkeit der getrennten Sammlung hin.
Need help?
Do you have a question about the S-PLASMA 55H UK and is the answer not in the manual?
Questions and answers