Installation - Philips MCD299/98 User Manual

Installation

Subwoofer
AC power
cord
Speaker
(right)
IMPORTANT!
– The type plate is located at the rear of
the system.
– The voltage selector located at the
rear of this system is preset at
220V-240V from the factory. For
countries that operate at 110V-127V,
please adjust to 110V-127V before you
switch on the system.
– Before connecting the AC power cord
on the rear of the subwoofer to the wall
outlet, ensure that all other connections
have been made.
– Never make or change any
connections with the power switched on.
– High voltage! Do not open. You run the
risk of getting an electric shock.
– The machine does not contain any
user-serviceable parts.
– Modification of the product could
result in hazardous radiation of EMC or
other unsafe operation.
10
pg001-pg020_MCD299-98-Eng-A
S-VIDEO
IN
AUDIO
TV IN
IN
VIDEO IN
FM wire antenna
A/V cord
AC CORD
R
SPEAKERS 6 Ω
L
Y/Pb/Pr OUT
A/V OUT
CONNECT TO SUB WOOFER
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).
Note:
– Before installation is finished, it is not
recommended to remove the protective plastic film
attached to the surface of the front panel to avoid
any scratch caused during installation.
10
S-VIDEO
AUDIO IN TV IN
IN
VIDEO IN
MW loop antenna
Speaker
(left)
2007.9.27, 13:04