Steps
1. Place the heat sink on the system board.
2. Tighten the four captive screws that secure the heat sink to the system board.
NOTE:
Tighten the captive screws in the sequential order mentioned on the heat sink [1 > 2 > 3 > 4].
NOTE:
The number of screws varies depending on the configuration ordered.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
Fan
Removing the fan
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
The following images indicate the location of the fan and provide a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
47