Chauvet COLORado BATTEN 144 TOUR Quick Reference Manual page 3

EN
Fuse
Replacement
DMX Linking
DMX Connection
Master/Slave
Connection
Mounting
Product
Mounting
Diagram
All manuals and user guides at all-guides.com
1.
Disconnect the product.
2.
With a Phillips #2 head screwdriver, unscrew the fuse holder cap.
3.
Remove the blown fuse and replace it with a good fuse of the same
type and rating.
4.
Screw the fuse holder cap back in its place and reconnect power.
The COLORado™ Batten 144 Tour will work with a DMX controller using
a regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The COLORado™ Batten 144 Tour uses a regular DMX data connection
for its DMX personalities: TOUR, BLOCK1, BLOCK2, ARC1, ARC1 +
D, ARC3, ARC3 + D, ARC3 + S, and HSV. See the User Manual to
connect and configure for DMX operation.
The COLORado™ Batten 144 Tour uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
COLORado™ Batten 144 Tour QRG
Overhead Mounting
Floor Mounting
3