Advertisement
XC-2 Ethernet Kit Quick Start Guide (1.1)
2.1 Connect the XC-2 to a network using DHCP
Plug-in the XC-2 using the 5V power supply. The PLL LED on the bottom of the board
lights up to indicate that the board has been powered up.
Connect the XC-2 to your network using an ethernet cable (not supplied). An LED
pattern flashes to show live connectivity.
The X1LEDA LED lights up to show that the application is running. The X2LEDB LED
lights up to show the board is successfully connected to the network.
Open your browser and go to:
http://xc2.local
Use the menu options to explore the device capabilities. You can flash the LEDs on
the XC-2, read real-time information about board features, and change the board to
use a static or automatic IP configuration.
2.2 Connect the XC-2 directly to a PC
Make sure that the XC-2 power supply is disconnected.
Configure your PC to connect to a valid static IP address on the 192.168.0 subnet,
for example 192.168.0.101.
Connect the XC-2 to your PC using an Ethernet cable.
Hold down firmly Button A on the XC-2 and plug-in the 5V power supply to the XC-2
board. Keep Button A held down until the LEDs stop flashing to force the board into
static IP mode.
Open your browser and go to http://192.168.0.100, the default static IP address of
the XC-2 board.
2.3 Webserver application - XC-2 buttons
The type of IP address used to connect to the webserver is set in the Configuration
page of the xc2.local website. Use the XC-2 buttons to override this setting when
you start the device:
Button A - uses a static IP address (default 192.168.0.100)
Button B - uses an automatic IP address
www.xmos.com
4/6
Advertisement
