Advertisement
XC-2 Ethernet Kit Quick Start Guide (1.1)
1 Introduction
The XC-2 Ethernet Kit is a rapid and cost effective route for developing Ethernet-based
products in XMOS Silicon. Based around the four-core XS1-G4 programmable device,
the XC-2 Kit provides the hardware needed to connect to a 10/100 Etherent system
using an RJ45 socket.
The XC-2 Ethernet Kit includes:
XC-2 Development Board
XTAG Connector which provides a JTAG interface between the board and XMOS
Tools
USB Cable to connect the XTAG to your development system
External 5V power supply
2 Getting Started
The XC-2 Kit includes a webserver application written in C and XC. The XS1-G4 serves
the website, and drives the protocol stack and ethernet hardware.
To use the webserver you need to plug the XC-2 board into a local network or your
PC. Make sure that you disable any firewall you may have running before trying to
connect to the website. If you do not want to run the webserver please go to the
Tools Support section 3.
Further information on the XC-2 is available from the XMOS web site. Download the
XC-2 tutorial, hardware manual, schematics and design files from: www.xmos.com/xc2.
www.xmos.com
2/6
Advertisement
