Cleaning The Terminal - Digicom PALLADIO ISDN User Manual

PALLADIO ISDN
PREFACE
All rights reserved; no part of this publication may be reproduced, stored in a retrieval
system, or trasmitted in any form or by any means, electronic, otherwise, without the prior
written permission of Digicom S.p.A..
The contents of this booklet may be modified without prior permission.
Every possible care has been taken in testing and putting together all the documentation
contained in this booklet, however Digicom can not take any responsability brought by the
use of this booklet.
ENVIROMENTAL CONDITIONS
ENVIRONMENTAL TEMPERATURE
from 0 to + 45°C
Rapid changes of temperature or humidity should be avoided (0,03°C/min).
This equipment, including cables, should be installed in an area free from:
Dust, humidity, heat from direct sun light.
Objects which irradiate heat. These could cause damage to the container
or other problems.
Objects which produce a strong electtromagnetic field (loudspeakers, etc.)
Liquids or chemical corrosive substances.

CLEANING THE TERMINAL

Use a clean and soft cloth. Wet the cloth with water or natural detergent if it
is necessary to remove any stains.
Never use chemical products such as petrol or solvents.
VIBRATIONS OR DROPPING
Caution against vibrations and dropping
In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
DECLARATION
We, Digicom S.p.A. registered office at: via Volta 39 - 21010 Cardano al
Campo (Varese - Italy)
declare under our sole responsability that the products:
Name: PALLADIO ISDN satisfies the basic requirement of the below indicated
Directive:
1999/5/CE of March 9 1999, R&TTE as having been designed in conformity
with the requirements of following Reference Standards:
- EN 55022
- EN 61000-3-3 - EN 55024
- EN 60950
WARNING
This is a class A product.
OF CONFORMITY
- EN 61000-3-2
- ETSI TBR 3
III
RELATIVE HUMIDITY
from 5 to 92% n.c..
Preface