Table of Contents
Advertisement
PALLADIO ISDN
7.
AT COMMAND SET DESCRIPTION
AT
Attention
All the characters following the letters 'AT' are commands. In AT command
mode ISDN modem automatically detects the Computer speed and parity
format. The ISDN modem will response using the same speed and parity
format of AT command.
A/
Repeat last command
Cause ISDN modem to repeat the last AT command. This command is neither
preceded by AT nor followed by CR
A
Answer incoming data call
Cause ISDN modem to go off-hook and attempt a handshake in answer mode
D
Dial
Instruct to go off-hook and execute the phone number.
D 0-9
Dial the dial string.
DS=0-3
Dial the dial string associated to the memory location (from 0
to 3) stored using &Z command
Dn1*n2
Dial two number (n1 and n2) for MLPPP at 128Kbps. If the
service access at 128Kbps is over a single telephone number
the n1 is egual to n2.
Example: ATD0331702611*0331702611
See also the command AT%A2 for MLPPP activation
E
Echo commands ON/OFF
Enable or disable echo of commands from the Computer to ISDN modem.
E0
Command echo disabled
E1
Command echo enabled
H
Hang up
Hang up the ISDN modem from the ISDN network.
H0
Hang up ISDN modem from the ISDN network (off-line). This
command is accepted only in Escape mode.
7.1
AT Command Set
Default= n/a
Default= n/a
Default= n/a
Default= n/a
Default= E1
Default= n/a
Advertisement
Table of Contents
