Hazard Warning Lights; Towing - freightliner Cargo Manual

In an Emergency

Hazard Warning Lights

The hazard warning light switch
the left switch bank on the instrument panel. Hazard
warning lights are operated by pushing the bottom of
the switch. When the hazard warning light switch is on,
all of the turn signal lights and both of the indicator
lights on the control panel will flash. To cancel the warn-
ing lights, push the top of the switch.
10/01/98
Fig. 10.1, Hazard Warning Light Switch
10.1
(Fig. 10.1) is located in
f601425a

Towing

WARNING
Do not tow an unbraked vehicle if the combined
weight of both vehicles is more than the sum of the
gross axle weight ratings (GAWR) of the towing ve-
hicle. Otherwise brake capacity will be inadequate,
which could result in personal injury or death.
IMPORTANT: When it is necessary to tow the ve-
hicle, make sure the instructions below are closely
followed to prevent damage to the vehicle.
Front Towing Hookup
1. Disconnect the battery ground cable.
2. If the vehicle is to be lifted and towed, remove the
drive axle shafts.
CAUTION
Failure to remove the axle shafts when towing the
vehicle with the rear wheels on the ground could
result in damage to the transmission and other
parts.
3. Cover the ends of the hubs with metal plates or
plywood cut to fit the axle opening, and drilled to fit