Gs W Nl Nh - Citizen iDP3240 User Manual

GS W nL nH

[Function]
[Code]
[Range]
[Outline]
[Caution]
Setting the print area width
<1D>H<57>H<nL><nH>
0 nL 255
0 nH 255
Sets the print area width specified by nL and nH.
• The print area width will be [(nL + nH 256) basic calculation
pitch].
Left Margin
• This command only works when it is entered at the beginning
of a line.
• The settings of this command have no effect on PAGE MODE,
but items set in PAGE MODE will be valid even after
STANDARD MODE resumes.
• If the value entered with this command exceeds the printable
area for one line, the entire area except the left margin is set
as the print area width.
• The basic calculation pitches are defined by GS P. Once
defined, the print area width is not changed if the basic
calculation pitch is changed by GS P.
• The print area width is calculated with the horizontal basic
calculation pitch (x) defined by GS P. A fraction resulting from
the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.
• If the first character to be mapped at the beginning of a line
has a width (Including the right spacing) greater than the print
area width, only that line is handled as follows:
(1) The print area is extended toward the right to accommodate
the first character, but not wider than the printable area.
Printable Area
A
Left Margin
Print Area Width
— 110 —
Printable Area
Print Area Width
Extended toward the right